How to Apply Monocoat Wood Finish

1. Getting Ready

Always start with clean, unfinished wood. Unfinished parts from TableLegs.com are pre-sanded with 180 grit. Finished parts are pre-sanded with 220 grit. If you have your own finished surface on which you would like to apply Monocoat, remove the finish completely.

2. Mixing Monocoat

Monocoat is made up of two main components. The correct ratio for Monocoat is 3 parts A (oil) to 1 part B (accelerator). If you use the entire content of both cans, it's already the correct 3:1 ratio. To determine how much oil you will need, use the following guidelines: Hardwoods: 350 mL will cover up to 175 sq ft.; 1.3L will cover up to 650 sq ft. Softwoods: 350 mL will cover up to 140 sq ft.; 1.3L will cover up to 520 sq ft. Douglas fir and reclaimed woods: 350 mL will cover up to 80 sq ft.; 1.3L will cover up to 290 sq ft.

Steps

1. Put on protective gloves and eye-wear.
2. Pour 3 parts of A (oil) into the plastic container.
3. Add 1 part of B (accelerator).
4. Stir until well blended.
5. Be sure to use your Monocoat shortly after opening. You can use the mixed solution for a couple days if it is stored in an airtight container in a cool location. The mixed oil will get darker and thicker in the can but it will not discolor the wood.

3. Applying Monocoat

Monocoat attaches directly to wood fiber. When applying Monocoat, remember that a little goes a long way. Use just enough to wet the surface. Work in a well-lit area. For two sided items such as tabletops, apply to the underside first.

Steps

1. Vacuum and clean the entire surface thoroughly.
2. With the foam paint brush applicator or a foam roller, apply the Monocoat mixture to the clean sanded wood surface. For large, flat pieces such as tabletops, you may pour the mixture directly on the surface and work it into the wood. Always work along the wood grain.
3. After coating the entire surface, remove all excess oil using a rag or shop towel.
4. Allow to dry before turning the newly finished side onto a clean, dry surface. Repeat the process to apply oil to the other side.
5. WARNING: Oil-saturated towels can spontaneously combust. You must place all used applicators and rags in water, or keep in a lidded, sealed metal container.

4. Second Application

As the name implies, Monocoat is designed to be a single-coat finish. At TableLegs.com, we recommend a light second application. Doing this extra step yields the best looking, most durable finish possible. Be sure to wait 24 hours before applying the second coat.

Steps

1. Sand the entire surface lightly along the wood grain with 300-600 grit sandpaper.
2. Vacuum and clean to remove any dust.
3. Apply a light second application of Monocoat.
4. Wipe off all excess oil, working along the wood grain.